I have read that it is best to use paint stripper to remove the old paint avoid sanding or anything that could cause dust. They are easy to find at paint stores. Then use a wire brush or knife to remove the last bits of paint! I also used a heat gun with great success, but be careful about burning the wood. This is a poultice that you leave on for 48 hour depending on test area indications and then peel away the blanket and remove all layers of paint.
They give off fewer fumes than solvent-based paint strippers, are cheaper and tend to work faster. Hi, I had a new European oak front door and frame fitted last year. We have a couple of removal products that can be used to strip back the paint but I would be worried that the Black treatment that is underneath may be affected as well. Hi Sam I have been reading through some of your interesting blogs, but I can not seem to find quite the correct item to use. Scrape off as much stripper off your tools as you can. However, if you are stripping lead paint, they do prevent getting into your lungs.
How to Remove Paint and Reveal the Natural Wood | how-tos | DIY
There were some thick varnish spots especially where a piece of small trim had been removed so we had to apply some more Citristrip to a few areas. I am so excited to share this little corner of the internet with you. Use fine sandpaper to remove any remaining varnish and create a porous surface for the new stain or sealer. Those bits that wind, rain, frost and sun couldn't remove came off with hook scraper very easily. Special care must be taken to make sure that all traces of the chemical are removed from the timber, or is effectively neutralised before any new finish is applied, failure to do this may result in a chemical reaction with the new finish.
I cannot guarantee that either of these will remover the primer but these are very good products for removal and its definitely worth trying them. Again a test area is strongly recommended. I want the new color to be dark blue but still be able to see the wood if that makes a bit of sense! If this or a number of others are not working for you then I am afraid the only solution would be sanding. We have removed the carpet from a downstairs room in our Edwardian House to reveal the mostly original stained floorboards. I have an old wooden ammo box with rope handles. All PeelAway products are supplied as a kit including an application spatula and protective blankets, to prevent the applied poultice or paste from drying out too quickly and before it has dissolved the paint or varnish.